Norm

ASTM F1290-98a(2011)

Standard Practice for Electrofusion Joining Polyolefin Pipe and Fittings

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie F17.20
Gepubliceerd op 01-02-2011
Taal Engels

1.1 This practice describes general procedures for making joints with polyolefin pipe and fittings by means of electrofusion joining techniques. These should be regarded as general procedures and not as a substitute for the installation procedures specified by the manufacturers. Manufacturers should be requested to supply specific recommendations for joining their products.

Note 1—Reference to the manufacturer in this practice is defined as the electrofusion fitting manufacturer.

1.2 The techniques covered are applicable only to joining polyolefin pipe and fittings of related polymer chemistry, for example, polyethylenes to polyethylenes using a polyethylene electrofusion fitting. Consult the manufacturer's recommendations for compatibility of the electrofusion fitting with the specific pipe or fitting material to be joined.

1.3 The electrofusion joining technique described can produce sound joints between polyolefin pipe and fittings, provided that all products involved (that is, pipe and fittings) meet the appropriate ASTM specifications.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 23.040.20
23.040.45
Nederlandse titel Standard Practice for Electrofusion Joining Polyolefin Pipe and Fittings
Engelse titel Standard Practice for Electrofusion Joining Polyolefin Pipe and Fittings

Winkelwagen

Subtotaal:

Ga naar winkelwagen