Norm

ASTM F1342/F1342M-05(2013)e1

Standard Test Method for Protective Clothing Material Resistance to Puncture

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie F23.20
Gepubliceerd op 01-12-2013
Taal Engels

1.1 This test method determines the puncture resistance of a protective clothing material specimen by measuring the force required to cause a pointed puncture probe to penetrate through the specimen. This test method describes three protocols that may be used: Method A, Method B, and Method C.

1.1.1 Method A requires the use of Probe A only. The probe used for testing shall be recorded in the test report.

1.1.1.1 Probe A may be used to measure puncture resistance for the following types of materials:

(1) Elastomeric materials
(2) Textiles
(3) Coated materials

1.1.2 Method B requires the use of Probe B. The probe used for testing shall be recorded in the test report.

1.1.2.1 Probe B may be used to measure puncture resistance for the following types of materials:

(1) Textiles
(2) Coated materials
Note 1Probe B is not suited for measuring the puncture resistance of unsupported elastomeric materials.

1.2 The values stated in SI units are to be regarded as the standard. The values in inch-pound units in brackets are for information purposes only. The values stated in each system may not be exact equivalents; therefore, each system must be used independently of the other, without combining values in any way.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 13.340.10
Nederlandse titel Standard Test Method for Protective Clothing Material Resistance to Puncture
Engelse titel Standard Test Method for Protective Clothing Material Resistance to Puncture

Winkelwagen

Subtotaal:

Ga naar winkelwagen