Norm

ASTM F1387 - 99(2005) en

Standard Specification for Performance of Piping and Tubing Mechanically Attached Fittings

  • Deze norm is ingetrokken sinds 01-05-2012

73,70 89,18 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 28
Gepubliceerd op 01-07-2005
Taal Engels

1.1 This specification establishes the performance characteristics required for mechanically attached fittings (MAFs) for use in piping and tubing systems. These fittings directly attach to pipe or tube by mechanical deformation of the pipe or tube or fitting, or a combination thereof, creating a seal and a restrained joint. The seal may be created via the mechanical deformation or created independently. Successful completion of the tests described constitutes completion of the technical portion of the qualification process.

1.2 Supplementary requirements are provided for use when additional testing or inspection is desired. These shall apply only when specified in part or whole by the purchaser in the order. Unless otherwise specified, U.S. Navy contracts shall invoke the supplementary requirements in whole.

1.3 Unless specific MAF types are specified, the term "MAF" shall apply to all types described herein.

1.4 The tests specified in Section and described in and Supplementary Requirements are applicable only to ascertain the performance characteristics of MAFs. These tests are not intended for use in the evaluation of non-MAF products.

1.5 A fire performance test is specified in Supplementary Requirement S7. This test provides general guidelines to determine the responsiveness of MAFs when subjected to fire. This test should not be considered for use to evaluate non-MAF products.

1.6 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.7 The following safety hazards caveat applies only to the tests listed in Section and the tests described in the Supplementary Section 13 and the Annex of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 23.060.01
Engelse titel Standard Specification for Performance of Piping and Tubing Mechanically Attached Fittings
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen