Norm

ASTM F1643-05(2012)

Standard Test Methods for Detention Sliding Door Locking Device Assembly

61,51

Over deze norm

Status Definitief
Aantal pagina's 11
Commissie F33.04
Gepubliceerd op 01-06-2012
Taal Engels

1.1 These test methods cover the apparatus, procedures, and acceptance conditions for evaluating the normal operational performance and the performance characteristics under assault, smoke, and fire conditions of sliding device assemblies in detention and correctional institutions. These test methods give an indication of the performance characteristics of devices in actual service. Such variables as installation and maintenance conditions are not considered.

1.2 It is the intent of these test methods to help ensure that detention sliding devices perform at or above minimum acceptable levels to control passage to unauthorized or secure areas, to confine inmates and to delay and frustrate escape attempts and resist vandalism. However, these test methods do not address door construction. It is recognized that in order to meet the intent of these test methods, door assemblies shall be compatible with the level of performance required by Test Methods F1450.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 91.190
Nederlandse titel Standard Test Methods for Detention Sliding Door Locking Device Assembly
Engelse titel Standard Test Methods for Detention Sliding Door Locking Device Assembly

Winkelwagen

Subtotaal:

Ga naar winkelwagen