Norm

ASTM F1790/F1790M-15

Standard Test Method for Measuring Cut Resistance of Materials Used in Protective Clothing with CPP Test Equipment

54,27

Over deze norm

Status Definitief
Aantal pagina's 10
Commissie F23.20
Gepubliceerd op 01-11-2015
Taal Engels

1.1 This test method covers the measurement of the cut resistance of a material when mounted on a mandrel and subjected to a cutting edge under a specified load using the Cut Protection Performance (CPP) Tester.

1.1.1 This procedure is not valid for high-porosity materials which allow cutting edge contact with the mounting surface prior to cutting.

1.1.2 Test apparatus may have limitations in testing materials with a thickness greater than 3 mm or having a high frictional coefficient such as elastomers.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 13.340.10
Nederlandse titel Standard Test Method for Measuring Cut Resistance of Materials Used in Protective Clothing with CPP Test Equipment
Engelse titel Standard Test Method for Measuring Cut Resistance of Materials Used in Protective Clothing with CPP Test Equipment

Winkelwagen

Subtotaal:

Ga naar winkelwagen