ASTM F1837M - 97(2007) en

Standard Specification for Heat-Shrink Cable Entry Seals (Metric)

  • Deze norm is ingetrokken sinds 01-10-2012

57,09 62,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 8
Gepubliceerd op 01-05-2007
Taal Engels

1.1 This specification covers the general requirements for heat-shrink cable entry seals. Cable entry seals are intended for making electrical cable penetrations into connection boxes, bulkheads, or other enclosures. These devices are suitable for both thin wall enclosures up to 5 mm (3/16 in.) thick and thick-wall enclosures of 5 mm to 19 mm (3/16 in. to 3/4 in.) thick.

1.2 Cable entry seals shall have factory-applied adhesive that provides the seal to wire and cable jackets.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to its use.


ICS-code 29.035.20
Engelse titel Standard Specification for Heat-Shrink Cable Entry Seals (Metric)
Vervangen door



Ga naar winkelwagen