ASTM F1895 - 10a en

Practice for Submersion of a Membrane Switch

  • Deze norm is ingetrokken sinds 01-01-2014

50,24 54,76 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 2
Gepubliceerd op 01-12-2010
Taal Engels

1.1 This test method establishes procedures for the submerging of a membrane switch to verify resistance to ingress of a specified liquid.

1.2 This test method can also be used to verify the ability of a membrane switch or graphics layer to act as a liquid seal for a finished product.

1.3 Additional test methods or practices can be incorporated to investigate specific results or capabilities.

1.4 This test method is a modification of National Electrical Manufacturers Assoc. (NEMA) Publication 250-1991 Section 6.10, which is a test for submersion of a finished product housing.

1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


ICS-code 31.220.20
Engelse titel Practice for Submersion of a Membrane Switch
Vervangen door



Ga naar winkelwagen