Over deze norm
1.1 This test method covers procedures to determine short-term indentation and residual indentation of resilient flooring, when subjected to concentrated loads.
1.2 The test methods appear in the following order:
Indentation by McBurney Test
Indentation and Residual Indentation
1.3 There are two procedures with their respective apparatus. The first (McBurney Test) is described in Sections to and is restricted to a spherical foot. It is only used for initial indentation measurements of VCT. The second is described in Sections to and has interchangeable feet with variable geometry. It is used to measure initial and residual indentation.
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
|Engelse titel||Standard Test Methods for Short-Term Indentation and Residual Indentation of Resilient Floor Covering|