Norm

ASTM F1914-07(2011)

Standard Test Methods for Short-Term Indentation and Residual Indentation of Resilient Floor Covering

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie F06.30
Gepubliceerd op 01-11-2011
Taal Engels

1.1 This test method covers procedures to determine short-term indentation and residual indentation of resilient flooring, when subjected to concentrated loads.

1.2 The test methods appear in the following order:

Section
Indentation by McBurney Test 4 to 10
Indentation and Residual Indentation 11 to 15

1.3 There are two procedures with their respective apparatus. The first (McBurney Test) is described in Sections 4 to 10 and is restricted to a spherical foot. It is only used for initial indentation measurements of VCT. The second is described in Sections 11 to 15 and has interchangeable feet with variable geometry. It is used to measure initial and residual indentation.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 97.150
Nederlandse titel Standard Test Methods for Short-Term Indentation and Residual Indentation of Resilient Floor Covering
Engelse titel Standard Test Methods for Short-Term Indentation and Residual Indentation of Resilient Floor Covering

Winkelwagen

Subtotaal:

Ga naar winkelwagen