Norm

ASTM F2095-07(2013)

Standard Test Methods for Pressure Decay Leak Test for Flexible Packages With and Without Restraining Plates

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie F02.40
Gepubliceerd op 01-08-2013
Taal Engels

1.1 These test methods cover the measurement of leaks in nonporous film, foil, or laminate flexible pouches and foil-sealed trays, which may be empty or enclose solid product. If product is enclosed, seals or surfaces cannot be in contact with water, oils, or other liquid.

1.2 These test methods will detect leaks at a rate of 1 × 10−4 sccs (standard cubic centimetres per second) or greater, in flexible packages. The limitation of leak rate is dependent on package volume as tested.

1.3 The following test methods are included:

1.3.1 Test Method A—Pressure Decay Leak Test for Flexible Packages Without Restraining Plates

1.3.2 Test Method B—Pressure Decay Leak Test for Flexible Packages With Restraining Plates

1.4 These test methods are destructive in that they require entry into the package to supply an internal pressure of gas, typically air or nitrogen, although other gases may be used. The entry connection into the flexible package must be leak-tight.

1.5 For porous packages, see 9.3.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 19.060
55.040
Nederlandse titel Standard Test Methods for Pressure Decay Leak Test for Flexible Packages With and Without Restraining Plates
Engelse titel Standard Test Methods for Pressure Decay Leak Test for Flexible Packages With and Without Restraining Plates

Winkelwagen

Subtotaal:

Ga naar winkelwagen