Norm

ASTM F2108-06(2011)

Standard Practice for Inspection of Transparent Parts by Prism

54,27

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie F07.08
Gepubliceerd op 01-12-2011
Taal Engels

1.1 Aerospace transparencies undergo high stresses induced by flight, environmental, or other factors. The transparency attachment points are especially subject to fatigue. These areas of fatigue are often obstructed or hidden from normal inspection. An inspector, following the techniques described in this practice, shall use a prism to view damage located near transparency bolt holes, voids, and delamination that are hidden by edge strips or frames.

1.2 The purpose of this practice is to provide acceptable methods for performing prism inspections of transparent materials with specific emphasis on aircraft windscreens and canopies. Caveats and lessons learned from experience are included to assist authors in writing tailored inspection instructions for specific applications.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 19.100
Nederlandse titel Standard Practice for Inspection of Transparent Parts by Prism
Engelse titel Standard Practice for Inspection of Transparent Parts by Prism

Winkelwagen

Subtotaal:

Ga naar winkelwagen