Over deze norm
1.1 This specification covers standard fitting geometries for molded short-pattern plastic fittings intended for use in drain, waste, and vent applications.
1.2 Fittings meeting the requirements of this specification are designed for use with outside-diameter controlled pipe. The body inside diameter can vary significantly as the wall thickness and outside diameter varies, and therefore, is not suitable for use as a fitting socket.
1.3 Fittings meeting the requirements of this specification shall be tested in accordance with the applicable requirements of Specifications or .
1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units which are provided for information only and are not considered standard.
1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
|Nederlandse titel||Standard Specification for Molded Drain, Waste, and Vent (DWV) Short-Pattern Plastic Fittings|
|Engelse titel||Standard Specification for Molded Drain, Waste, and Vent (DWV) Short-Pattern Plastic Fittings|