Norm

ASTM F2203-13

Standard Test Method for Linear Measurement Using Precision Steel Rule

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie F02.20
Gepubliceerd op 01-05-2013
Taal Engels

1.1 This test method covers the measurement of linear dimension of flexible packages and packaging materials. It is recommended for use with an allowable tolerance range of 3 mm (1/8 in.) or greater based on gage repeatability and reproducibility presented in the Precision and Bias section.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

Details

ICS-code 17.040.01
Nederlandse titel Standard Test Method for Linear Measurement Using Precision Steel Rule
Engelse titel Standard Test Method for Linear Measurement Using Precision Steel Rule

Winkelwagen

Subtotaal:

Ga naar winkelwagen