ASTM F2321 - 05 en

Standard Specification for Flexible Insulated Temporary By-Pass Jumpers

  • Deze norm is ingetrokken sinds 01-10-2013

57,09 62,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 10
Gepubliceerd op 01-04-2005
Taal Engels

1.1 These specifications cover the manufacture and testing of flexible insulated temporary bypass jumpers (bypass jumpers) used on energized power lines and equipment.

1.2 It is common practice for the user of this protective equipment to prepare complete instructions and safety regulations to govern in detail the correct and safe use of such equipment. Also see .

1.3 The use and maintenance of this equipment are beyond the scope of these specifications.

1.4 These specifications for a system of bypass jumpers is covered in four parts as follows:

Clamps for Bypass Jumpers
Ferrules for Bypass Jumpers
Cable for Bypass Jumpers
Bypass Jumpers (complete assemblywith clamps, ferrules, and cable)

1.5 Each of the four parts is an entity of itself, but is listed as a part of the system for completeness and clarification.

1.6 The values stated in SI units are to be regarded as the standard. See ASTM SI 10.

The following precautionary caveat pertains only to the test method portions, Sections , , , and of these specifications. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.


ICS-code 29.240.20
Engelse titel Standard Specification for Flexible Insulated Temporary By-Pass Jumpers
Vervangen door



Ga naar winkelwagen