Norm

ASTM F2378-05(2016)

Standard Test Method for Sealability of Sheet, Composite, and Solid Form-in-Place Gasket Materials

50,65

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie F03.10
Gepubliceerd op 01-10-2016
Taal Engels

1.1 This test method covers a means of evaluating the sealing properties of sheet, composite, and solid form-in-place gasket materials (see Classification F104 or F868) at room temperature, and may be used for fluid (gas or liquid) leak rate measurements. It utilizes relatively short hold times and is not intended to predict long-term performance in application.

1.2 This test method is suitable for evaluating the sealing characteristics of a gasket material under different press loads by measuring the leakage rate. This test method may be used as an acceptance test when the producer and user have agreed to specific test conditions for the following parameters: (1) test medium, (2) internal pressure of the medium, (3) press load on the gasket specimen, and (4) the surface finish of the platens.

1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and to determine the applicability of regulatory limitations prior to use.

Details

ICS-code 21.140
Nederlandse titel Standard Test Method for Sealability of Sheet, Composite, and Solid Form-in-Place Gasket Materials
Engelse titel Standard Test Method for Sealability of Sheet, Composite, and Solid Form-in-Place Gasket Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen