Norm

ASTM F2468-05(2011)

Standard Classification for Specifying Silicone Adhesives and Sealants for Transportation Applications

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie F03.30
Gepubliceerd op 01-05-2011
Taal Engels

1.1 This classification covers silicone adhesives and sealants intended for but not limited to sealing and retaining metallic and nonmetallic component assemblies in transportation applications. The materials cure to an elastomeric state by their specified cure system and mechanism.

Note 1—The classification system may serve many of the needs of industries using silicone materials. This classification is subject to revision, as the need requires; therefore, the latest revision should always be used.

1.2 This classification is intended to be a means of classifying silicone materials. It is not intended for engineering design purposes.

1.3 It is not the intent of this classification to include pressure-sensitive or hot-melt adhesives.

1.4 In all cases in which the provisions of this classification system would conflict with the referenced ASTM standard for a particular method, the latter shall take precedence.

1.5 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.6 The following safety hazards caveat pertains only to the test methods portion, Section 7, of this classification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 55.040
71.100.55
Nederlandse titel Standard Classification for Specifying Silicone Adhesives and Sealants for Transportation Applications
Engelse titel Standard Classification for Specifying Silicone Adhesives and Sealants for Transportation Applications

Winkelwagen

Subtotaal:

Ga naar winkelwagen