Norm

ASTM F2508 - 11 en

Standard Practice for Validation and Calibration of Walkway Tribometers Using Reference Surfaces

  • Deze norm is ingetrokken sinds 01-11-2012

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 5
Gepubliceerd op 15-03-2011
Taal Engels

1.1 This practice is intended to establish the parameters for validation and calibration of walkway tribometers.

1.2 This practice provides a walkway tribometer supplier with a procedure and suite of reference surfaces to validate his walkway tribometer by properly ranking and differentiating the surfaces.

1.3 This practice provides the user of a walkway tribometer with a procedure and suite of reference surfaces to test calibration of his instrument.

1.4 This practice describes the necessary materials, specifications, and the cleaning process for reference materials, as well as the requirements for the validation of a suppliers walkway tribometer and calibration of a users walkway tribometer.

1.5 This practice applies to walkway tribometers without reference to the nature of the scale of the readings produced by them. The scale used in the reports of validation and calibration must be the same, and are to be those of the instrument or defined for the instrument.

1.6 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only and are not considered standard.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 17.040.20
Engelse titel Standard Practice for Validation and Calibration of Walkway Tribometers Using Reference Surfaces
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen