Norm

ASTM F2754/F2754M-09(2013)

Standard Test Method for Measurement of Camber, Cast, Helix and Direction of Helix of Coiled Wire

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie F04.15
Gepubliceerd op 01-10-2013
Taal Engels

1.1 This test method covers the various standard methods that are used for measuring camber, cast, helix, and helix direction. The wire may be coiled with or without a spool.

1.2 This test method applies to round wire that has a diameter between 0.0127 to 4.78 mm (0.0005 to 0.188 in.). It also applies to flat or shaped wire.

1.3 This test method does not apply to superelastic nitinol wire. It does apply to the as-drawn condition of nitinol wire.

1.4 This test method does not apply to the measurement of the straightness of straightened to length wire and tubing.

1.5 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 77.140.65
Nederlandse titel Standard Test Method for Measurement of Camber, Cast, Helix and Direction of Helix of Coiled Wire
Engelse titel Standard Test Method for Measurement of Camber, Cast, Helix and Direction of Helix of Coiled Wire

Winkelwagen

Subtotaal:

Ga naar winkelwagen