Norm

ASTM F2866-11

Standard Test Method for Flammability of a Membrane Switch in Defined Assembly

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie F01.18
Gepubliceerd op 01-07-2011
Taal Engels

1.1 This test method covers the determination of the flammability characteristics of a membrane switch.

1.2 This test method defines the MSB rating of a membrane switch. Each character of the MSB rating represents a discrete characteristic of a membrane switch performance under destructive thermal loading.

1.3 This test procedure will be destructive, but should provide an insight into the relative performance flame-resistance characteristics of differing designs or assemblies, or both.

1.4 This test method will focus on the use of convective contact (burner flame) method for ignition, though other methods of ignition are available.

1.5 This test method is designed to determine if the membrane switch assembly will add (or detract) from the flame propagation from an exterior flame/fire source.

1.6 If this test is intended to be used for an internal flammability source then set up the unit under test (UUT) appropriately and note it in the test scope and results.

1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 31.220.20
Nederlandse titel Standard Test Method for Flammability of a Membrane Switch in Defined Assembly
Engelse titel Standard Test Method for Flammability of a Membrane Switch in Defined Assembly

Winkelwagen

Subtotaal:

Ga naar winkelwagen