ASTM F2945 - 12 en

Standard Specification for Polyamide 11 Gas Pressure Pipe, Tubing, and Fittings

  • Deze norm is ingetrokken sinds 27-11-2012

57,20 69,21 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 15
Gepubliceerd op 15-08-2012
Taal Engels

1.1 This specification covers requirements and test methods for the characterization of polyamide 11 pipe, tubing, and fittings for use in fuel gas piping. The pipe and fittings covered by this specification are intended for use in the transport of fuel gases.

1.1.1 This specification does not cover threaded pipe. Generic fusion guidelines are given in Appendix X1. Design considerations are discussed in Appendix X2. In-plant quality control programs are specified in Annex A1.

1.2 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.4 The following is an index of the annexes and appendixes in this specification:



Annex A1

In-Plant Quality Control for sizes up to 12 in.

Annex A2

PA-11 Butt Fusion Fittings



Appendix X1

Butt Fusion Guidelines for PA-11 Piping

Appendix X2

Design Consideration

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


Engelse titel Standard Specification for Polyamide 11 Gas Pressure Pipe, Tubing, and Fittings
Vervangen door



Ga naar winkelwagen