Norm

ASTM F36-15

Standard Test Method for Compressibility and Recovery of Gasket Materials

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie F03.20
Gepubliceerd op 01-01-2015
Taal Engels

1.1 This test method covers determination of the short-time compressibility and recovery at room temperature of sheet-gasket materials, form-in-place gaskets, and in certain cases, gaskets cut from sheets. It is not intended as a test for compressibility under prolonged stress application, generally referred to as “creep,” or for recovery following such prolonged stress application, the inverse of which is generally referred to as “compression set.” Also, it is not intended for tests at other than room temperature. A resiliency characteristic (the amount recovered expressed as a percentage of the compressed thickness) may also be calculated from the test data where desired.

1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 21.140
Nederlandse titel Standard Test Method for Compressibility and Recovery of Gasket Materials
Engelse titel Standard Test Method for Compressibility and Recovery of Gasket Materials

Winkelwagen

Subtotaal:

Ga naar winkelwagen