Norm

ASTM F468M - 06(2018) en

Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)

58,09 70,29 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 11
Gepubliceerd op 01-09-2018
Taal Engels

1.1 This specification covers the requirements for commercial wrought nonferrous bolts, hex cap screws, and studs in nominal thread diameters M6 to M36 inclusive manufactured from a number of alloys in common use and intended for general service applications.

1.2 Unless otherwise specified, nuts used on these bolts, cap screws, and studs shall conform to the requirements of Specification F467M. Nuts shall be of the same alloy group as the fastener on which they are used and shall have a specified minimum proof stress equal to or greater than the specified minimum tensile strength stress of the fastener on which they are used.

1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

Note 1: This specification is the metric companion of Specification F468.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 21.060.10
Nederlandse titel Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
Engelse titel Standard Specification for Nonferrous Bolts, Hex Cap Screws, and Studs for General Use (Metric)
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen