Norm

ASTM F477-14

Standard Specification for Elastomeric Seals (Gaskets) for Joining Plastic Pipe

48,24

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie F17.20
Gepubliceerd op 15-09-2014
Taal Engels

1.1 This specification covers elastomeric seals (gaskets) used to seal the joints of plastic pipe used for gravity, low-pressure, and high-pressure applications. This refers to push-on joints which require no internal or external pressure to effect the initial seal.

1.2 Requirements are given for natural or synthetic rubber gaskets, or a combination of both.

1.3 The text of this specification references notes, footnotes, and appendixes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the specification.

1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.5 The following precautionary caveat pertains only to the test method portion, Section 7, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 23.040.80
Nederlandse titel Standard Specification for Elastomeric Seals (Gaskets) for Joining Plastic Pipe
Engelse titel Standard Specification for Elastomeric Seals (Gaskets) for Joining Plastic Pipe

Winkelwagen

Subtotaal:

Ga naar winkelwagen