Norm

ASTM F879 - 10 en

Standard Specification for Stainless Steel Socket Button and Flat Countersunk Head Cap Screws

  • Deze norm is ingetrokken sinds 01-06-2012

50,60 61,23 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 6
Gepubliceerd op 01-05-2010
Taal Engels

1.1 This specification covers the chemical and mechanical requirements for stainless steel inch hexagon socket button (SBHCS) and flat countersunk (SFHCS) head cap screws with nominal thread 0.060 through 0.625 in. intended for use in applications requiring general corrosion resistance.

1.2 Two groups of austenitic stainless steel alloys and three conditions are covered. See Table 1 and Table 2.

1.3 UnitsThe values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

1.4 The following precautionary caveat pertains only to the test method portion, Section 12, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 21.060.10
Engelse titel Standard Specification for Stainless Steel Socket Button and Flat Countersunk Head Cap Screws
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen