ASTM F880 - 02(2008)e1 en

Standard Specification for Stainless Steel Socket-Set Screws

  • Deze norm is ingetrokken sinds 01-06-2012

50,27 60,83 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 5
Gepubliceerd op 01-05-2008
Taal Engels

1.1 This specification covers the requirements for austenitic grade stainless steel socket-set screws (SSS) sizes 0.060 through 0.500 in., in two conditions, AF and CW.

1.2 UnitsThe values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

Note 1—A complete metric companion to Specification F880 has been developedF880M; therefore, no metric equivalents are shown in this specification.

1.3 The following hazards caveat pertains only to Test Method Section, Section 12 of this specification. This standard does not purport to address (all of) the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


ICS-code 21.060.10
Engelse titel Standard Specification for Stainless Steel Socket-Set Screws
Vervangen door



Ga naar winkelwagen