Norm

ASTM F880-12

Standard Specification for Stainless Steel Socket, Square Head, and Slotted Headless-Set Screws

54,27

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie F16.04
Gepubliceerd op 01-06-2012
Taal Engels

1.1 This specification covers the requirements for austenitic grade stainless steel socket-set screws (SSS) sizes 0.060 through 1.000 in. square head set screws (SHSS) sizes 0.190 through 1.500 in., and slotted headless set screws (HSS) 0.060 through 0.750 in., in two conditions, AF and CW.

1.2 Units???The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

Note 1???A complete metric companion to Specification F880 has been developed???F880M; therefore, no metric equivalents are shown in this specification.

1.3 The following hazards caveat pertains only to Test Method Section, Section 12 of this specification. This standard does not purport to address (all of) the safety problems associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 21.060.10
Nederlandse titel Standard Specification for Stainless Steel Socket, Square Head, and Slotted Headless-Set Screws
Engelse titel Standard Specification for Stainless Steel Socket, Square Head, and Slotted Headless-Set Screws

Winkelwagen

Subtotaal:

Ga naar winkelwagen