Norm

ASTM F894-13

Standard Specification for Polyethylene (PE) Large Diameter Profile Wall Sewer and Drain Pipe

54,27

Over deze norm

Status Definitief
Aantal pagina's 10
Commissie F17.26
Gepubliceerd op 01-08-2013
Taal Engels

1.1 This specification covers requirements and test methods for materials, dimensions, workmanship, ring stiffness, flattening, joint systems, and a form of marking for large diameter, 10 to 120 in. (250 to 3050 mm), inside diameter based polyethylene (PE) pipe of profile wall construction and with bell and spigot, heat fusion, extrusion welded or elctrofusion joints for use in gravity flow applications, such as for sewers and drains.

Note 1Pipe produced to this specification should be installed in accordance with Practice D2321 and with the manufacturer's recommendations.

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 23.040.20
Nederlandse titel Standard Specification for Polyethylene (PE) Large Diameter Profile Wall Sewer and Drain Pipe
Engelse titel Standard Specification for Polyethylene (PE) Large Diameter Profile Wall Sewer and Drain Pipe

Winkelwagen

Subtotaal:

Ga naar winkelwagen