Norm

ASTM F903-10

Standard Test Method for Resistance of Materials Used in Protective Clothing to Penetration by Liquids

54,27

Over deze norm

Status Definitief
Aantal pagina's 10
Commissie F23.30
Gepubliceerd op 01-01-2010
Taal Engels

1.1 This test method is used to test specimens of protective clothing and candidate materials and constructions to be used in protective clothing. The resistance to visible penetration of the test liquid is determined with the liquid in continuous contact with the normally outside surface of the test specimen.

1.2 In some cases, significant amounts of hazardous materials will permeate specimens that pass the penetration tests. For more sensitive analysis use Test Method F739 to determine permeation.

1.3 This test method is not applicable to finger tips or crotch areas of gloves, which are possible failure points.

1.4 The values as stated in inch-pound units are to be regarded as the standard. The values in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific hazards are given in Section 7.

Details

ICS-code 13.340.10
Nederlandse titel Standard Test Method for Resistance of Materials Used in Protective Clothing to Penetration by Liquids
Engelse titel Standard Test Method for Resistance of Materials Used in Protective Clothing to Penetration by Liquids

Winkelwagen

Subtotaal:

Ga naar winkelwagen