Norm

ASTM F905-04(2011)

Standard Practice for Qualification of Polyethylene Saddle-Fused Joints

48,24

Over deze norm

Status Definitief
Aantal pagina's 3
Commissie F17.60
Gepubliceerd op 01-04-2011
Taal Engels

1.1 This practice describes test criteria suitable for qualification of polyethylene saddle-fused joints. These tests may be conducted by suppliers or users to qualify saddle-fused joints in accordance with the requirements found in the Department of Transportation (DOT) Code of Federal Regulations (CFR) Title 49, Part 192.283. At the discretion of the end user, these tests may also be conducted by users to qualify personnel making saddle fusion joints per DOT CFR 49, Part 192.285.

1.2 The impact resistance test described is a nonstandard test. This is not the only test that may be used to qualify saddle fusion joints per DOT regulations.

1.3 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversion to SI units that are provided for information only and are not considered standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

Nederlandse titel Standard Practice for Qualification of Polyethylene Saddle-Fused Joints
Engelse titel Standard Practice for Qualification of Polyethylene Saddle-Fused Joints

Winkelwagen

Subtotaal:

Ga naar winkelwagen