Over deze norm
1.1 This test method describes a procedure for non-destructive testing using acoustic emission (AE) testing for aerial personnel devices, which do not have a supplemental load handling attachment.
1.1.1 Equipment Covered—This test method covers the following types of vehicle-mounted insulated aerial personnel devices:
188.8.131.52 Extensible boom aerial personnel devices,
184.108.40.206 Articulating boom aerial personnel devices, and
220.127.116.11 Any combination of 18.104.22.168 and 22.214.171.124.
1.1.2 Equipment Not Covered—This test method does not cover any of the following equipment:
126.96.36.199 Material-handling aerial devices,
188.8.131.52 Digger-derricks with platform, and
184.108.40.206 Cranes with platform.
1.2 The AE test method is used to detect and area-locate emission sources. Verification of emission sources may require the use of other nondestructive test (NDT) methods, such as radiography, ultrasonics, magnetic particle, liquid penetrant, and visual inspection. Warning—This test method requires that external loads be applied to the superstructure of the vehicle under test. During the test, caution must be taken to safeguard personnel and equipment against unexpected failure or instability of the vehicle or components.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|Engelse titel||Standard Test Method for Acoustic Emission for Aerial Personnel Devices Without Supplemental Load Handling Attachments|