Norm

ASTM F959M - 13 en

Standard Specification for Compressible-Washer-Type Direct Tension Indicators for Use With Structural Fasteners (Metric)

50,60 61,23 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 5
Gepubliceerd op 01-03-2013
Taal Engels

1.1 This specification covers the requirements for compressible-washer-type direct tension indicators capable of indicating the achievement of a specified minimum bolt tension in a structural bolt.

1.2 Two types of direct tension indicators in nominal diameter sizes M16 through M36 are covered:

1.2.1 Type 8.8—direct tension indicators for use with Specification A325M bolts, and

1.2.2 Type 10.9—direct tension indicators for use with Specification A490M bolts.

1.3 Direct tension indicators are intended for installation under either a bolt head or a hardened washer. (See Research Council on Structural Connections: Specification for Structural Joints Using ASTM A325 or A490 Bolts.)

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 The following precautionary statement pertains only to the test methods portions, Section 12, and Appendix X1 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 21.060.30
Engelse titel Standard Specification for Compressible-Washer-Type Direct Tension Indicators for Use With Structural Fasteners (Metric)
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen