Norm

ASTM G105-16

Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests

49,88

Over deze norm

Status Definitief
Aantal pagina's 9
Commissie G02.30
Gepubliceerd op 01-06-2016
Taal Engels

1.1 This test method covers laboratory procedures for determining the resistance of metallic materials to scratching abrasion by means of the wet sand/rubber wheel test. It is the intent of this procedure to provide data that will reproducibly rank materials in their resistance to scratching abrasion under a specified set of conditions.

1.2 Abrasion test results are reported as volume loss in cubic millimetres. Materials of higher abrasion resistance will have a lower volume loss.

1.3 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

Nederlandse titel Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests
Engelse titel Standard Test Method for Conducting Wet Sand/Rubber Wheel Abrasion Tests

Winkelwagen

Subtotaal:

Ga naar winkelwagen