Norm

ASTM G174 - 04(2017) en

Standard Test Method for Measuring Abrasion Resistance of Materials by Abrasive Loop Contact

50,60 61,23 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 7
Gepubliceerd op 15-07-2017
Taal Engels

1.1 This test method covers ranking rigid engineering materials for abrasion resistance in rubbing against aluminum oxide abrasive finishing tape. Though most solids can be tested, this test method addresses its use for metals, and coatings applied to metals.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.

Details

ICS-code 25.100.70
Engelse titel Standard Test Method for Measuring Abrasion Resistance of Materials by Abrasive Loop Contact
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen