Norm

ASTM G6-07(2013)

Standard Test Method for Abrasion Resistance of Pipeline Coatings

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie D01.48
Gepubliceerd op 01-06-2013
Taal Engels

1.1 This test method of accelerated test is a procedure for determining the relative resistance of steel pipeline coatings to abrasion by a slurry of coarse abrasive and water. The method is intended to apply to the testing of all types of electrical insulating pipeline coatings and tapes, including thermoplastics, thermoset, and bituminous materials.

1.2 Pipeline coatings are not normally subjected to the type of abrasion herein specified.

1.3 Metallic protective coatings such as zinc may be compared visually, but do not meet the electrical requirements of this test method.

1.4 The values stated in SI units to three significant decimals are to be regarded as the standard. The values given in parentheses are for information only.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 25.220.20
Nederlandse titel Standard Test Method for Abrasion Resistance of Pipeline Coatings
Engelse titel Standard Test Method for Abrasion Resistance of Pipeline Coatings

Winkelwagen

Subtotaal:

Ga naar winkelwagen