ASTM G95 - 07 en

Standard Test Method for Cathodic Disbondment Test of Pipeline Coatings (Attached Cell Method)

  • Deze norm is ingetrokken sinds 01-06-2013

44,68 54,06 Incl BTW

Over deze norm

Status Ingetrokken
Aantal pagina's 4
Gepubliceerd op 01-07-2007
Taal Engels

1.1 This test method covers accelerated procedures for simultaneously determining comparative characteristics of coating systems applied to steep pipe exterior for the purpose of preventing or mitigating corrosion that may occur in underground service where the pipe will be in contact with natural soils and will receive cathodic protection. They are intended for use with samples of coated pipe taken from commercial production and are applicable to such samples when the coating is characterized by function as an electrical barrier.

1.2 This test method is intended to facilitate testing of coatings where the test cell is cemented to the surface of the coated pipe specimen. This is appropriate when it is impractical to submerge or immerse the test specimen as required by Test Methods G 8, G 42, or G 80. Coating sample configuration such as flat plate and small diameter pipe may be used, provided that the test procedure remains unchanged.

1.3 This test method allows options that must be identified in the report.

1.4 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only.

This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.


ICS-code 23.040.99
Engelse titel Standard Test Method for Cathodic Disbondment Test of Pipeline Coatings (Attached Cell Method)
Vervangen door



Ga naar winkelwagen