Norm

ASTM G99-05(2016)

Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus

54,27

Over deze norm

Status Definitief
Aantal pagina's 5
Commissie G02.40
Gepubliceerd op 01-06-2016
Taal Engels

1.1 This test method covers a laboratory procedure for determining the wear of materials during sliding using a pin-on-disk apparatus. Materials are tested in pairs under nominally non-abrasive conditions. The principal areas of experimental attention in using this type of apparatus to measure wear are described. The coefficient of friction may also be determined.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Details

ICS-code 17.040.20
Nederlandse titel Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus
Engelse titel Standard Test Method for Wear Testing with a Pin-on-Disk Apparatus

Winkelwagen

Subtotaal:

Ga naar winkelwagen