Norm

IEC 60204-1:2005+A1:2009 en

Veiligheid van machines - Elektrische uitrusting van machines - Deel 1: Algemene eisen

  • Deze norm is ingetrokken sinds 17-10-2016

315,75

Over deze norm

Status Ingetrokken
Aantal pagina's 126
Commissie Elektrische uitrusting van machines
Gepubliceerd op 01-02-2009
Taal Engels
This part of IEC 60204 applies to the application of electrical, electronic and programmable electronic equipment and systems to machines not portable by hand while working, including a group of machines working together in a co-ordinated manner. The equipment covered by this part of IEC 60204 commences at the point of connection of the supply to the electrical equipment of the machine (see 5.1). This part of IEC 60204 is applicable to the electrical equipment or parts of the electrical equipment that operate with nominal supply voltages not exceeding 1000 V for alternating current (a.c.) and not exceeding 1500 V for direct current (d.c.), and with nominal supply frequencies not exceeding 200 Hz. This part of IEC 60204 does not cover all the requirements (for example guarding, interlocking, or control) that are needed or required by other standards or regulations in order to protect persons from hazards other than electrical hazards. Each type of machine has unique requirements to be accommodated to provide adequate safety. This part specifically includes, but is not limited to, the electrical equipment of machines as defined in 3.35. This part of IEC 60204 does not specify additional and special requirements that can apply to the electrical equipment of machines that, for example: – are intended for use in open air (i.e. outside buildings or other protective structures); – use, process, or produce potentially explosive material (for example paint or sawdust); – are intended for use in potentially explosive and/or flammable atmospheres; – have special risks when producing or using certain materials; – are intended for use in mines; – are sewing machines, units, and systems (which are covered by IEC 60204-31); – are hoisting machines (which are covered by IEC 60204-32). Power circuits where electrical energy is directly used as a working tool are excluded from this part of IEC 60204.

Details

ICS-code 29.020
Nederlandse titel Veiligheid van machines - Elektrische uitrusting van machines - Deel 1: Algemene eisen
Engelse titel Safety of machinery - Electrical equipment of machines - Part 1: General requirements
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen