Norm

IEC 61300-3-35:2015-RL en;fr

Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-35: Examinations and measurements - Visual inspection of fibre optic connectors and fibre-stub transceivers (Redline version with track changes)

140,42

Over deze norm

Status Definitief
Aantal pagina's 72
Commissie Fibre optic communications
Gepubliceerd op 01-06-2015
Taal Engels, Frans
IEC 61300-3 describes methods for quantitatively assessing the end face quality of a polished fibre optic connector or of a fibre optic transceiver using a fibre-stub type interface. Sub-surface cracks and fractures are not considered in this standard. In general, the methods described in this standard apply to 125 μm cladding fibres contained within a ferrule and intended for use with sources of ≤ 2 W of input power. However, portions are applicable to non-ferruled connectors and other fibre types. Those portions are identified where appropriate. It is not the intention of this standard that the size of scratches should be measured, the dimensions and requirements are selected such that they can be estimated. There is no need to measure for example if a scratch is 2,3 μm wide.  - THIS REDLINE VERSION PROVIDES YOU WITH QUICK AND EASY WAY TO COMPARE ALL THE CHANGES BETWEEN THIS STANDARD AND ITS PREVIOUS EDITION. A VERTICAL BAR APPEARS IN THE MARGIN WHEREVER A CHANGE HAS BEEN MADE. ADDITIONS AND DELETIONS ARE DISPLAYED IN RED, WITH DELETIONS BEING STRUCK THROUGH.

Details

ICS-code 33.180.20
Engelse titel Fibre optic interconnecting devices and passive components - Basic test and measurement procedures - Part 3-35: Examinations and measurements - Visual inspection of fibre optic connectors and fibre-stub transceivers (Redline version with track changes)

Winkelwagen

Subtotaal:

Ga naar winkelwagen