IEC 62717:2014+A1:2015 en;fr

LED modules voor algemene verlichting - Prestatie-eisen

249,27 301,62 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 201
Gepubliceerd op 01-09-2015
Taal Engels, Frans
IEC 62717+A1 specifies the performance requirements for LED modules, together with the test methods and conditions, required to show compliance with this standard. The following types of LED modules are distinguished and schematically shown in Figure 1: Type 1: integrated LED modules for use on d.c. supplies up to 250 V or on a.c. supplies up to 1 000 V at 50 Hz or 60 Hz. Type 2: LED modules operating with part of separate controlgear connected to the mains voltage, and having further control means inside (“semi-integrated”) for operation under constant voltage, constant current or constant power. Type 3: LED modules where the complete controlgear is separate from the module (nonintegrated) for operation under constant voltage, constant current or constant power. The requirements of this standard relate only to type testing. Recommendations for whole product testing or batch testing are under consideration. This standard covers LED modules, based on inorganic LED technology that produces white light. Life time of LED modules is in most cases much longer than the practical test times. Consequently, verification of manufacturer’s life time claims cannot be made in a sufficiently confident way, because projecting test data further in time is not standardised. For that reason the acceptance or rejection of a manufacturers life time claim, past an operational time as stated in 6.1, is out of the scope of this standard. Instead of life time validation this standard has opted for lumen maintenance codes at a defined finite test time. Therefore, the code number does not imply a prediction of achievable life time. The categories, represented by the code, are lumen-depreciation character categories showing behaviour in agreement with manufacturer’s information which is provided before the test is started. In order to validate a life time claim, an extrapolation of test data is needed. A general method of projecting measurement data beyond limited test time is under consideration. The pass/fail criterion of the life time test as defined in this standard is different from the life time metrics claimed by manufacturers. For explanation of recommended life time metrics, see Annex C. The separate electronic controlgear for LED modules as mentioned in Type 2 and Type 3 is not part of the testing against the requirements of this standard. Protection for water and dust ingress, see B.3.


ICS-code 29.140.99
Nederlandse titel LED modules voor algemene verlichting - Prestatie-eisen
Engelse titel LED modules for general lighting - Performance requirements



Ga naar winkelwagen