Norm

IEC/PAS 61076-2-010:2020 en

Connectors for electrical and electronic equipment - Product requirements - Part 2-010: Circular connectors - Detail specification for push-pull connectors with locking mechanism, based on mating interfaces according to IEC 61076-2-101, IEC 61076-2-109, IEC 61076-2-111 and IEC 61076-2-113

225,69 246,00 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 41
Commissie Elektromechanische onderdelen voor elektronisch materieel
Gepubliceerd op 01-07-2020
Taal Engels
IEC 61076-2-101 specifies circular connectors with a push-pull locking mechanism of asize derived from and thus being compatible with M12 screw-locking connectors (freeconnectors with screw-locking according to IEC 61076-2-101, IEC 61076-2-109,IEC 610762111or IEC 61076-2-113 are compatible to push-pull fixed interfaces accordingto this document) and with mating interfaces according to IEC 61076-2-101, IEC 61076-2-109,IEC 61076-2-111 or IEC 61076-2-113.This document covers both1) power connectors with current ratings up to 16 A and voltage ratings up to 630 V, typicallyused for power supply and power applications in industrial premises, and2) connectors for data and signal transmission with frequencies up to 500 MHz.These connectors consist of both, fixed and free connectors, either rewireable or nonrewireable,with M12 push-pull locking as explained above. Male connectors have roundcontacts from Ø0,6 mm up to Ø1,5 mm. In addition, the push-pull mechanisms consist oftwo different push-pull designs:a) An outer push-pull for male and female fixed connector, where the locking groove isplaced onto the outer cylindric surface of the housing. The outer push-pull for female fixedconnectors is made for two different types of male connectors. It has locking means forboth types on its outer surface.b) An inner push-pull for female fixed connectors, where the locking means are placed ontothe inner cylindric surface of the housing.NOTE 3 For design and dimensions. see 5.3.3.The different codings provided by IEC 61076-2 and mentioned within this document, preventthe mating of accordingly coded male or female connectors to any other similarly sizedinterfaces, covered by other standards and the cross-mating between the different codingsprovided by IEC 61076-2.

Details

ICS-code 31.220.10
Engelse titel Connectors for electrical and electronic equipment - Product requirements - Part 2-010: Circular connectors - Detail specification for push-pull connectors with locking mechanism, based on mating interfaces according to IEC 61076-2-101, IEC 61076-2-109, IEC 61076-2-111 and IEC 61076-2-113

Winkelwagen

Subtotaal:

Ga naar winkelwagen