Norm

ISO 10816-3:2009 en;fr

Mechanische trillingen - Beoordeling van machinetrillingen door meting aan de niet-draaiende delen - Deel 3: Industriële machines met nominale spanning boven 15 kW en nomimale snelheid tussen 120 tpm en 15 000 tpm wanneer in situ gemeten

48,19

Over deze norm

Status Definitief
Aantal pagina's 12
Commissie Conditie-bewaking van machines
Gepubliceerd op 01-02-2009
Taal Engels, Frans
This part of ISO 10816 gives criteria for assessing vibration levels when measurements are made in situ. The criteria specified apply to machine sets having a power above 15 kW and operating speeds between 120 r/min and 15 000 r/min. The machine sets covered by this part of ISO 10816 include: - steam turbines with power up to 50 MW; - steam turbine sets with power greater than 50 MW and speeds below 1 500 r/min or above 3 600 r/min (not included in ISO 10816-2); - rotary compressors; - industrial gas turbines with power up to 3 MW; - generators; - electrical motors of any type; - blowers or fans. The following are excluded from this part of ISO 10816: - land-based steam turbine generator sets with power greater than 50 MW and speeds of 1 500 r/min, 1 800 r/min, 3 000 r/min or 3 600 r/min (see ISO 10816-2); - gas turbine sets with power greater than 3 MW (see ISO 10816-4); - machine sets in hydraulic power generating and pumping plants (see ISO 10816-5); - machines coupled to reciprocating machines (see ISO 10816-6); - rotodynamic pumps including integrated electric motors, i.e. where the impeller is mounted directly on the motor shaft or is rigidly attached to it (see ISO 10816-7); - rotary positive displacement compressors (e. g. screw compressors); - reciprocating compressors; - reciprocating pumps; - submerged motor-pumps; - wind turbines. The criteria of this part of ISO 10816 apply to in situ broad-band vibration measurements taken on the bearings, bearing pedestals, or housing of machines under steady-state operating conditions within the nominal operating speed range. They relate to both acceptance testing and operational monitoring. The evaluation criteria of this part of ISO 10816 are designed to apply to both continuous and non-continuous monitoring situations. This part of ISO 10816 encompasses machines which may have gears or rolling element bearings, but does not address the diagnostic evaluation of the condition of those gears or bearings. The criteria are applicable only for the vibration produced by the machine set itself and not for vibration which is transmitted to the machine set from external sources.

Details

ICS-code 17.160
21.020
Nederlandse titel Mechanische trillingen - Beoordeling van machinetrillingen door meting aan de niet-draaiende delen - Deel 3: Industriële machines met nominale spanning boven 15 kW en nomimale snelheid tussen 120 tpm en 15 000 tpm wanneer in situ gemeten
Engelse titel Mechanical vibration - Evaluation of machine vibration by measurements on non-rotating parts - Part 3: Industrial machines with nominal power above 15 kW and nominal speeds between 120 r/min and 15 000 r/min when measured in situ
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen