Norm

ISO 11003-2:2019 en

Lijmen - Bepaling van het gedrag bij afschuiving van structurele lijmverbindingen - Deel 2: Schuifproef met dikke trekstaven

73,95 89,48 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 14
Gepubliceerd op 01-06-2019
Taal Engels
ISO 11003-2 specifies a test method for determining the shear behaviour of an adhesive in a single lap joint bonded assembly when subjected to a tensile force. The test is performed on specimens consisting of thick, rigid adherends, with a short length of overlap, in order to obtain the most uniform distribution of shear stresses possible and to minimize other stress states which initiate failure. This test method may be used to determine: - the shear-stress against shear-strain curve to failure of the adhesive; - the shear modulus of the adhesive; - other adhesive properties that can be derived from the stress/strain curve such as secant shear modulus and maximum shear stress; - the effect of temperature, environment, test speed, etc., on these properties. This document does not apply in case of adhesion failure.

Details

ICS-code 83.180
Nederlandse titel Lijmen - Bepaling van het gedrag bij afschuiving van structurele lijmverbindingen - Deel 2: Schuifproef met dikke trekstaven
Engelse titel Adhesives - Determination of shear behaviour of structural adhesives - Part 2: Tensile test method using thick adherends
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen