Norm

ISO 12129-2:1995 en

Plain bearings - Part 2: Tolerances on form and position and surface roughness for shafts, flanges and thrust collars

31,57

Over deze norm

Status Definitief
Aantal pagina's 3
Gepubliceerd op 30-03-1995
Taal Engels
Specifies tolerances on form and position as well as the surface roughness of shafts, flanges and thrust collars as used in plain bearing units. Applicable to journal or thrust plain bearing units or to a combination of both, installed either horizontally or vertically. Not applicable to crankshaft bearing units in combustion engines.

Details

ICS-code 21.100.10
Nederlandse titel Plain bearings - Part 2: Tolerances on form and position and surface roughness for shafts, flanges and thrust collars
Engelse titel Plain bearings - Part 2: Tolerances on form and position and surface roughness for shafts, flanges and thrust collars

Winkelwagen

Subtotaal:

Ga naar winkelwagen