Norm

ISO 14590:2005 en

Cold-reduced steel sheet of high tensile strength and low yield point with improved formability

  • Deze norm is ingetrokken sinds 08-08-2016

73,12

Over deze norm

Status Ingetrokken
Aantal pagina's 13
Commissie Metalen algemeen
Gepubliceerd op 01-02-2005
Taal Engels
This International Standard applies to killed cold-reduced steel sheet of two types that are commercially available in the world. Type 1 (Table 1) represents steels that are produced to mechanical properties only and Type 2 (Table 2) are produced to both mechanical and chemical properties. Bake hardening steels are included in both types. All these steels are commonly produced by continuous annealing. Cold-reduced sheet less than 600 mm wide may be slit from wide sheet and will be considered as sheet. This International Standard does not cover steels designated as commercial quality or drawing qualities (covered in ISO 3574), steels of structural quality (covered in ISO 4997) or steels of higher strength with improved formability (covered in ISO 13887).

Details

ICS-code 77.140.50
Nederlandse titel Cold-reduced steel sheet of high tensile strength and low yield point with improved formability
Engelse titel Cold-reduced steel sheet of high tensile strength and low yield point with improved formability
Vervangt
Wordt vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen