Norm

ISO 1641-3:2011 en

Kopfrezen en gleuffrezen - Deel 3: Afmetingen en benaming van frezen met 7/24 conische schachten.

48,19

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie Gereedschappen
Gepubliceerd op 15-06-2011
Taal Engels
This part of ISO 1641 specifies the general dimensions and designation of the following milling cutters with 7/24 taper shanks: ? end mills, flat-ended or ball-nosed - normal series and long series (manual changers); ? slot drills - short series and normal series (manual changers); ? end mills, flat-ended - normal series and long series (automatic changers). Tool shanks with 7/24 taper for manual tool changers are in accordance with ISO 297. Tool shanks with 7/24 taper for automatic tool changers are in accordance with ISO 7388-1 and ISO 7388-2. It is not applicable to end mills and slot drills with cylindrical shank, which are dealt with in ISO 1641-1; it is not applicable to those with Morse taper shank, which are dealt with in ISO 1641-2. This part of ISO 1641 is not applicable to solid hardmetal end mills and slot drills.

Details

ICS-code 25.100.20
Nederlandse titel Kopfrezen en gleuffrezen - Deel 3: Afmetingen en benaming van frezen met 7/24 conische schachten.
Engelse titel End mills and slot drills - Part 3: Dimensions and designation of milling cutters with 7/24 taper shanks
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen