Norm

ISO 22621-6:2010 en

Kunststofleidingsystemen voor de voorziening van gasvormige brandstoffen voor maximale druk tot en met 2 MPa (20 bar) - Polyamide (PA) - Deel 6: Richtlijnen voor het ontwerp, hantering en installatie

  • Deze norm is ingetrokken sinds 13-06-2012

98,05

Over deze norm

Status Ingetrokken
Aantal pagina's 21
Commissie Kunststofleidingsystemen voor gasvoorzieningen
Gepubliceerd op 15-04-2010
Taal Engels
This part of ISO 22621 specifies a code of practice dealing with polyamide (PA) piping systems, intended to be buried outside buildings and used for the supply of gaseous fuels. It is applicable to mains and service lines, the components of which are prepared for jointing by scraping and/or machining, and gives instructions for the design, storage, handling, transportation, laying conditions and fusion quality control of PA pipes and fittings up to and including 250 mm outside diameter, as well as subsequent joint testing, backfilling, pipe system testing, commissioning and decommissioning. The jointing methods covered by this part of ISO 22621 are butt fusion jointing and electrofusion jointing. No special precautions are necessary for areas exposed to the influence of mining and earthquakes other than those precautions mentioned in this part of ISO 22621. It is the responsibility of users of this part of ISO 22621 to take existing and new national regulations into account.

Details

ICS-code 75.200
83.140.30
Nederlandse titel Kunststofleidingsystemen voor de voorziening van gasvormige brandstoffen voor maximale druk tot en met 2 MPa (20 bar) - Polyamide (PA) - Deel 6: Richtlijnen voor het ontwerp, hantering en installatie
Engelse titel Plastics piping systems for the supply of gaseous fuels for maximum operating pressures up to and including 2 MPa (20 bar) - Polyamide (PA) - Part 6: Code of practice for design, handling and installation
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen