Norm

ISO 2507-1:1995 en

Thermoplastics pipes and fittings - Vicat softening temperature - Part 1: General test method

31,57

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie Kunststofleidingsystemen
Gepubliceerd op 02-02-1995
Taal Engels
The method specified is based on determining the temperature at which a standard indenter, under a force of 50 N ± 1 N, penetrates 1 mm into the surface of a test piece cut from the wall of a pipe or fitting while the temperature is raised at a constant rate. Is applicable only to thermoplastics materials for which it is possible to measure the temperature at which the rate of softening becomes rapid. Is based on ISO 306:1994 which, however, applies to materials in the form of sheets.

Details

ICS-code 23.040.20
23.040.45
Nederlandse titel Thermoplastics pipes and fittings - Vicat softening temperature - Part 1: General test method
Engelse titel Thermoplastics pipes and fittings - Vicat softening temperature - Part 1: General test method

Winkelwagen

Subtotaal:

Ga naar winkelwagen