Norm

ISO 2974:2013 en

Dieselmotoren - 60 ° inwendige conus voor hoge-druk-brandstofinspuitonderdelen

  • Deze norm is ingetrokken sinds 28-11-2016

48,19

Over deze norm

Status Ingetrokken
Aantal pagina's 9
Commissie Wegvoertuigen
Gepubliceerd op 01-03-2013
Taal Engels
This International Standard specifies the dimensional requirements of end-connections for highpressure fuel injection equipment components, used on diesel (compression-ignition) engines. It is applicable to externally threaded 60° female cones (see Figures 1, 2, 5, and 6) and intended for use with high-pressure fuel injection pipe assemblies with tube outside diameters of - up to and including 12 mm for integral female cones (see Table 1), and - up to and including 9 mm for fabricated female cones (see Table 2). Details of the pipe connection ends referenced in this document are shown in ISO 13296.

Details

ICS-code 43.060.40
Nederlandse titel Dieselmotoren - 60 ° inwendige conus voor hoge-druk-brandstofinspuitonderdelen
Engelse titel Diesel engines - 60 degree female cones for high-pressure fuel injection components
Vervangt
Wordt vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen