Norm

ISO 3573:2008 en

Hot-rolled carbon steel sheet of commercial and drawing qualities

  • Deze norm is ingetrokken sinds 24-12-2012

48,19

Over deze norm

Status Ingetrokken
Aantal pagina's 9
Commissie Chemische analyse van ijzer en staal
Gepubliceerd op 04-04-2008
Taal Engels
This International Standard applies to hot-rolled carbon steel sheet of commercial and drawing qualities. Hot-rolled steel sheet is suitable for many applications where the presence of oxide or scale, or normal surface imperfections disclosed after removal of oxide or scale, are not objectionable. It is not suitable for applications where the surface is of prime importance. Commercial quality sheet (HR1) is intended for general fabricating purposes where sheet is used in the flat condition or for bending, moderate forming and welding operations. It is commonly produced in the range of thickness 0,8 mm to 12,5 mm inclusive, and in widths of 600 mm and over, in coils and cut lengths. Drawing quality sheet (HR2, HR3, HR4) is intended for drawing or severe forming, including welding. It is commonly produced in the range of thickness 0,8 mm to 12,5 mm inclusive and in widths of 600 mm and over, in coils and cut lengths. Drawing quality sheet is furnished according to all the requirements of this International Standard, or, by agreement when ordered, to fabricate an identified part, in which case the mechanical property requirements do not apply. Drawing qualities are identified as follows: HR2 - Drawing quality HR3 - Deep drawing quality HR4 - Deep drawing quality aluminum killed. Hot-reduced sheet less than 600 mm wide can be slit from wide sheet and will be considered as sheet.

Details

ICS-code 77.140.50
Nederlandse titel Hot-rolled carbon steel sheet of commercial and drawing qualities
Engelse titel Hot-rolled carbon steel sheet of commercial and drawing qualities
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen