Norm

ISO 3951-1:2013 en

Sampling procedures for inspection by variables - Part 1: Specification for single sampling plans indexed by acceptance quality limit (AQL) for lot-by-lot inspection for a single quality characteristic and a single AQL

164,52

Over deze norm

Status Definitief
Aantal pagina's 93
Commissie Toepassing van statistische methoden
Gepubliceerd op 01-09-2013
Taal Engels
This part of ISO 3951 is primarily designed for use under the following conditions: a) where the inspection procedure is to be applied to a continuing series of lots of discrete products all supplied by one producer using one production process; b) where only a single quality characteristic, x, of these products is taken into consideration, which must be measurable on a continuous scale; c) where production is stable (under statistical control) and the quality characteristic, x, is distributed according to a normal distribution or a close approximation to the normal distribution; d) where a contract or standard defines a lower specification limit, L, an upper specification limit, U, or both; an item is qualified as conforming if and only if its measured quality characteristic, x, satisfies the appropriate one of the following inequalities: 1) x ≥ L (i.e. the lower specification limit is not violated); 2) x ≤ U (i.e. the upper specification limit is not violated); 3) x ≥ L and x ≤ U (i.e. neither the lower nor the upper specification limit is violated). Inequalities 1) and 2) are called cases with a single specification limit and 3), a case with double specification limits. Where double specification limits apply, it is assumed in this part of ISO 3951 that conformance to both specification limits is equally important to the integrity of the product. In such cases, it is appropriate to apply a single AQL to the combined percentage of a product outside the two specification limits. This is referred to as combined control.

Details

ICS-code 03.120.30
Nederlandse titel Sampling procedures for inspection by variables - Part 1: Specification for single sampling plans indexed by acceptance quality limit (AQL) for lot-by-lot inspection for a single quality characteristic and a single AQL
Engelse titel Sampling procedures for inspection by variables - Part 1: Specification for single sampling plans indexed by acceptance quality limit (AQL) for lot-by-lot inspection for a single quality characteristic and a single AQL
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen